EVOLUTION GUN WORKS Viper Venom Sight Mount Fits Glock (49313)

Our sights for Glock are meant to be installed from the left to the right. The dovetail has a progressive taper to allow for easier install.
Simply remove the rear sight on your gun and replace it with our mount in order to mount your Vortex Viper/Venom, Burris FastFire, or Docter red-dot sight. No alterations are required.
You can take our mount off and replace your rear sight at any time. Mounting hardware included.

This mount fits Glocks all generation:

- Glock 17
- Glock 19
- Glock 20
- Glock 21
- Glock 22
- Glock 23
- Glock 24
- Glock 26
- Glock 27
- Glock 29
- Glock 30
- Glock 31
- Glock 32
- Glock 33
- Glock 34
- Glock 35
- Glock 37
- Glock 38
- Glock 39
- Glock 41
- Glock 42
- Glock 43
- Glock 46
- Canik TP9SF
- Bersa BP9CC

Does not fit Glock MOS models:

- Glock 17 Gen 4 MOS
- Glock 19 Gen 4 MOS
- Glock 34 Gen 4 MOS
- Glock 40 Gen 4 MOS
- Glock 41 Gen 4 MOS
- Glock 35 Gen 4 MOS
- Glock 34 Gen 5 MOS

Installation Instructions

- Remove the rear sight
- Install the EGW Sight Mount in the dovetail
- Tighten set screw (if applicable)
- Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque mounting screws to 15in/lbs

DISCLAIMER: This product is not manufactured, authorized, endorsed, or warranted by GLOCK. GLOCK does not warrant or represent that this product is compatible with GLOCK pistols.